Spark Plugs; Cvt Cover - BRP can-am COMMANDER 2017 Series Operator's Manual

Wipe off any spillage.

Spark Plugs

Access to Spark Plugs
1. Remove both seats.
2. Remove upper console retaining
screws and plastic rivets.
3. Slightly lift upper console to allow
removal of lower console.
4. Remove lower console plastic riv-
ets.
5. Pull lower console out of location.
Spark Plug Removal
Unplug spark plug cable.
NOTE: Spark plug removal procedure
is the same for both cylinders.
Clean spark plug and cylinder head
with pressurized air.
CAUTION Always wear safety
goggles when using pressurized air.
Unscrew spark plug completely then
remove it.
219001685-001_a
RH SIDE — REAR CYLINDER
1. Spark plug
tmo2011-001-111_a
LH SIDE — FRONT CYLINDER
1. Spark plug
Spark Plug Installation
Prior to installation make sure that con-
tact surface of cylinder head and spark
plug is free of grime.
Using a feeler gauge, set the spark plug
gap.
0.7 mm - 0.8 mm (.028 in - .031 in)
Apply a small amount of copper-based
anti-seize lubricant over spark plug
threads.
Screw spark plug into cylinder heads
by hand and tighten with a torque
wrench and a proper socket.
Spark plug

CVT Cover

NOTE: For a better understanding,
some illustrations are taken with en-
gine out of vehicle. To perform the
following instructions, it is not neces-
sary to remove engine.
This CVT is lubrication free. Never lu-
bricate any components except drive
pulley one-way clutch.
______________
MAINTENANCE PROCEDURES
SPARK PLUG GAP
TORQUE
20 N•m ± 2.4 N•m
(15 lbf•ft ± 2 lbf•ft)
105