Skis; Handlebar - BRP SKI-DOO MX Z X 600RS 2016 Manual

PARTS TO BE INSTALLED
TIGHTENING TORQUE
Shock absorber retaining
nuts

Skis

Ensure ski leg bushings are still on ski legs.
1. Install ski stopper on the ski.
Position indicator at front and make sure
NOTE:
the bump in the ski is in the groove of the ski stop-
per.
mmr2008-049-028_a
TYPICAL
1. Ski stopper
2. Bushings
2. Install ski on ski leg using the hardware as
shown.
mbl2015-002-012_a
TYPICAL - EXCEPT ADJUSTABLE STANCE
1. Ski stopper (predelivery kit)
2. M10 x 130 bolt (previously removed)
3. M10 flat washer (predelivery kit)
4. M10 flanged nut (predelivery kit)
5. Ski axle
Tighten flanged nut to specification.
TIGHTENING TORQUE
Ski retaining nuts
6 / 13
48 N•m (35 lbf•ft)
48 N•m (35 lbf•ft)
2016-5

Handlebar

1. Remove the tape securing the handlebar
wiring.
2. Loosen the lower steering extension retaining
screws.
mbl2012-008-012_a
1. Steering extension
2. Retaining screws
3. Tighten steering extension lower screws to
specification.
TIGHTENING TORQUE
Steering extension
lower screws
4. If necessary, adjust handlebar so that brake
fluid reservoir is level, tighten steering exten-
sion upper screws to specification.
TIGHTENING TORQUE
Steering extension
upper screws
5. Tighten steering electrical harness locking tie,
then cut exceeding strip.
mbl2014-007-004_a
FRONT OF HANDLEBAR
1. Locking tie
24 N•m (18 lbf•ft)
24 N•m (18 lbf•ft)
PREDELIVERY