Recommended Oil; Injection Oil Level Verification - BRP Lynx 600R E-TEC 2018 Original Operator's Manual

Table of Contents

Advertisement

FUEL AND OIL
WARNING
– Always stop engine before refu-
eling. Open cap slowly.
– If a differential pressure condi-
tion is noticed (whistling sound
heard when loosening fuel tank
cap) have vehicle inspected
and/or repaired before further
operation.
– Fuel is flammable and explosive
under certain conditions.
– Never use an open flame to
check fuel level.
– Never smoke or allow flame or
spark in vicinity.
– Always work in a well-ventilated
area.
– Never top up the fuel tank be-
fore placing the vehicle in a
warm area. As temperature in-
creases, fuel expands and may
overflow.
– Always
wipe
spillage from the vehicle.
NOTE: Do not sit or lean on seat when
fuel tank cap is not properly installed.

Recommended Oil

600 HO E-TEC and 800R E-TEC
ENGINE
600 HO
E-TEC
800R E-TEC
NOTICE
The engine of this snow-
mobile has been developed and val-
idated using the recommended BRP
XPS™ oil. BRP recommends the
use of its recommended XPS oil or
equivalent. Damages caused by oil
which is not suitable for this oil in-
jected 2-stroke direct fuel injection
engine may not be covered by the
BRP limited warranty.
______________
70
off
any
fuel
RECOMMENDED
INJECTION OIL
XPS SYNTHETIC
2-STROKE OIL(F)
(P/N 619 590 106)
1200 4-TEC and 900 ACE
ENGINE
1200 4-TEC
SYNTHETIC OIL (F)
900 ACE
(P/N 619 590 114)
NOTICE
The engine of this snow-
mobile has been developed and val-
idated using the BRP XPS™ Synthe-
tic 4-stroke oil. BRP recommends
the use of its XPS Synthetic 4-stroke
or equivalent.
by oil which is not suitable for this
4-stroke engine may not be covered
by the BRP limited warranty.
If the recommended oil is not avail-
able, use SAE 0W-40 synthetic-based
oil that meets or exceeds the require-
ments for API service classification
SM.
Injection Oil Level
Verification
The injection oil reservoir is located
behind the RH side panel. See
TROLS, INSTRUMENTS AND EQUIP-
MENT
for opening procedure.
Always maintain a sufficient amount of
recommended injection oil in the injec-
tion oil reservoir.
fmo2012-003-012_a
TYPICAL
1. Injection oil reservoir
2. Level marks (1/4, 1/2, 3/4)
RECOMMENDED
ENGINE OIL
XPS 4-STROKE
Damages caused
CON-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lynx 800r e-tec 2018Lynx 1200 4-tec 900 ace 2018

Table of Contents