Air Injection Valve Filter - BRP BOMBARDIER DS250 2006 Shop Manual

vmo2006-014-044_a
TYPICAL
1. Air filter housing
2. Drain tube
3. Clamp
If liquid/deposits are found, squeeze and remove
the clamp. Pull drain tube out and empty it.
CAUTION: Do not start engine when liquid/
deposits are found in the drain tube.
When liquid/deposits are found, the air filter must
be inspected/dried/replaced depending on its con-
dition.
Removal
Unscrew clamp retaining air intake hose to carbu-
retor.
vmr2006-068-002_a
1. Air intake hose
2. Carburetor
Unscrew air intake duct clamp from air filter hous-
ing.
vmr2006-068
Subsection 03 (AIR INTAKE SYSTEM)
vmr2006-068-003_a
1. Air intake duct
2. Air filter housing
3. Exhaust shield
Remove air filter, see procedure above.
Unscrew bolts holding air filter housing to frame
then slide air intake hose inside air filter housing.
vmr2006-068-004_a
1. Air filter housing bolts
2. Air intake hose
Remove air filter housing.
Installation
Properly reinstall removed parts in the reverse or-
der of their removal.
Apply Loctite 5150 (silicone sealant) (P/N 293 800
086) to air intake hose groove to seal the hose and
air filter housing.

AIR INJECTION VALVE FILTER

Removal
From the left side of vehicle, disconnect hoses
from air injection valve.
Section 03 ENGINE
35