Driver's Seat; Passenger Seat; Fuel Reservoir Cap; Winch (Models With Winch) - BRP can-am COMMANDER 2017 Series Operator's Manual

EQUIPMENT
Position the belt as low as possible
across your hips. Then, pull the belt
against your shoulder for a snug fit.
NOTE: Slide the latch as required to
adjust the seat belt.
WARNING
Wear seat belt properly. Make sure
it is not twisted or defective.
To release the seat belt, push on the
red button on the seat belt buckle.

10) Driver's Seat

The driver's seat can be adjusted for-
ward and backward.
To adjust seat, move the seat lever to
unlock the seat. Release the lever to
lock the seat into desired position.
WARNING
Never adjust the seat position
while driving.
The driver's seat can be removed eas-
ily:
– Tilt seat forward by releasing latch
between seat cushion and backrest.
– Pull seat upwards.
A convenient storage compartment is
located under the driver's seat.
tmo2011-001-700_a
1. Storage compartment
______________
70

11) Passenger Seat

The passenger seat is not adjustable.
The passenger seat can be tilted for-
ward for removal by releasing the latch
located between the seat cushion and
the backrest. Once tilted forward the
seat can be removed by pulling up-
wards.

12) Fuel Reservoir Cap

The fuel reservoir cap is located on the
right hand side of the vehicle behind
the passenger seat.
tmo2014-001-019_a
1. Fuel reservoir cap
FUEL
Refer to
mation on fueling procedure and fuel
requirements.
13) Winch (Models with
Winch)
The winch can be actuated inside the
vehicle using the winch control switch
on the upper console.
219001677-001_a
TYPICAL - WINCH
subsection for infor-