Battery; Fuses - BRP CAN-AM OUTLANDER 6x6 2017 Series Operator's Manual

MAINTENANCE PROCEDURES

Battery

CAUTION Never charge a bat-
tery while installed in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
NOTICE
Never remove the battery
sealing cap.
Battery Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
NOTICE
Always
BLACK (-) battery cable first.
Remove retaining screws, battery
holder then pull the battery out of
frame.
vmo2012-012-031_a
1. Battery holder
2. Retaining screws
Battery Cleaning
Clean battery, battery casing and bat-
tery posts using a solution of baking
soda and water.
Remove corrosion from battery cable
terminals and battery posts using a
firm wire brush.
______________
144
disconnect
Battery Installation
Battery installation is the reverse of the
removal procedure.
NOTICE
Always connect RED (+)
battery cable first.

Fuses

CAUTION Always remove key
from D.E.S.S. post before replacing
a defective fuse.
Fuse Inspection
Check if filament is melted.
If filament is melted, replace damaged
FUSE LOCATION
fuse, refer to
for proper rating.
A15E0KY
TYPICAL
1. Fuse
2. Check if melted
NOTICE
Do not use a higher rated
fuse as this can cause severe dam-
age.
Front Fuse Box Location
Pull upwards and front to remove the
gauge support from its location.
tables
1
2