vmr2007-051-006_a
1. Arrow printed on belt
2. Drive pulley (front)
3. Driven pulley (rear)
4. Rotation direction
Turn the driven pulley until the low-
est portion of the cogs on the external
surface of drive belt is even with the
driven pulley edge.
tmo2013-003-060_a
1. Lowest portion of cogs even with external
surface of drive belt
Drive and Driven Pulleys
Inspecting the Drive and Driven
Pulleys
This inspection must be performed by
an authorized Can-Am dealer, repair
shop, or person of your own choosing
for maintenance, repair, or replace-
ment.
Drive Pulley
Inspect the bushings of the sliding
sheave of the drive pulley, replace
worn parts.
Driven Pulley
Inspect the bushings of the cam and of
the sliding sheave of the driven pulley,
replace worn parts.
Battery
CAUTION Never charge a bat-
tery while installed in vehicle.
These vehicles are equipped with a
VRLA battery (Valve Regulated Lead
Acid). It is a maintenance-free type
battery, there is no need to add water
to adjust electrolyte level.
NOTICE
sealing cap.
Battery Removal
Disconnect BLACK (-) cable first then
RED (+) cable.
NOTICE
BLACK (-) battery cable first.
Remove retaining screws, battery
holdier then pull the battery out of
frame.
vmo2012-012-031_a
1. Battery holder
2. Retaining screws
Battery Cleaning
Clean battery, battery casing and bat-
tery posts using a solution of baking
soda and water.
______________
MAINTENANCE PROCEDURES
Never remove the battery
Always
disconnect
163