Cvt Cover Installation - BRP can-am COMMANDER 2017 Series Operator's Manual

MAINTENANCE PROCEDURES
WARNING
Never touch CVT while engine is
running. Never drive vehicle when
CVT cover is removed.
WARNING
Engine must be cool before cover
is removed. Always wear protec-
tive gloves when removing cover.
Place the vehicle on a level surface.
Select PARK position.
CVT Cover Access
1. Remove LH seat.
2. Remove nine plastic rivets to re-
move LH lateral console panel.
NOTE: Use flat head screwdriver sup-
plied in tool kit to remove plastic rivets.
3. Carefully pull out the panel.
4. Remove eight plastic rivets to re-
move under seat storage compart-
ment.
tmo2013-003-047_a
1. LH console panel
2. Under seat storage compartment
3. Plastic rivets
NOTE: This part will still be attached to
the vehicle by the seat belt. Do not de-
tach.
______________
106
CVT Cover Removal
Remove the thirteen CVT cover
screws.
NOTE: The four CVT cover lower
screws are accessible through the
square holes in the central skid plate.
tmo2013-004-011_a
1. Central skid plate
2. Access holes
NOTE: Remove the center top screw
last to support the cover during re-
moval.
NOTE: Do not use and impact tool to
remove CVT cover screws.
Remove the CVT cover and its gasket.
Vmr2012-018-004_a
1. CVT cover lower screws
2. CVT cover screws
3. CVT cover

CVT Cover Installation

Install the center top screw of first.
Tighten the CVT cover screws as per
following sequence.