Installation - BRP EVINRUDE Johnson 5007118 Installation Instructions Manual

WARNING
Improper installation of this kit could
result in personal injury due to loss of boat
control.
A boat designed for remote steering might
have a lower maximum rated horsepower
for a tiller-steered outboard than shown on
the certification plate. To avoid overpower-
ing a boat designed and rated for remote
steering, contact boat manufacturer for
tiller-steered maximum rated horsepower.
To prevent accidental starting while servic-
ing, disconnect battery leads from battery.
Twist and remove all spark plug leads.
To prevent injury from contact with a rotat-
ing propeller, remove propeller before ser-
vicing and when running outboard on a
flushing device.
Nautical Orientation
4 of 14
INSPECTION
Before installation, check boat for obstructions
that could interfere with free movement of tiller
handle when steering or tilting outboard.
CAUTION
To avoid damaging the tiller handle when
tilting the outboard up, position the out-
board to clear obstacles in the motor well
and boat.

INSTALLATION

Disconnect the battery cables at the battery.
Remove any screws from steering arm holes.
Make sure all paint or locking material is cleaned
from threads.
Place angle adjustment plate in pocket of
steering arm bracket.
The steering arm can be postitioned straight, or
angled 15° port or starboard by moving the
adjustment plate.
1
1. Plate adjustment for tiller in CENTER postion.
1
1. Plate adjustment for tiller in PORT postion.
1
1. Plate adjustment for tiller in STARBOARD postion.
005083
005084
005085