Crankgear; Removing And Installing V-Ribbed Belt; Summary Of Components - Vehicles Without Air Conditioning - Skoda FABIA 2000 Workshop Manual

FABIA 2000 1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
13 – Crankgear
13-1

Removing and installing V-ribbed belt

Summary of components - Vehicles without air conditioning

Note
♦ Mark the rotation direction before removing the V-ribbed belt. Reversing the rotation direction of an already used
belt may destroy it.
♦
Pay attention to the correct position of the ribbed V-belt in the belt pulley when installing it.
1 - Coolant pump
removing and installing
⇒ Chapter 19-2
2 - Bracket
for clamp
removing and installing
⇒ Chapter 15-1
3 - Screw
4 - Clamp
5 - 25 Nm
replace
6 - Generator
to facilitate positioning of the
generator on the holder,
drive the bushing of the re-
taining screw slightly back-
wards
7 - Screw
8 - 30 Nm
replace
9 - 45 Nm
10 - 25 Nm
coat with -AMV 105 500-
(Loctite 242) before inserting
11 - Bracket
for generator
12 - Guide pulley
13 - Washer
Camber towards the outside
14 - 20 Nm
Left-hand thread
coat with -AMV 154 100- (Loctite 648) before inserting
15 - Belt pulley
for crankshaft
16 - 100 Nm
to release and tighten lock flywheel
♦ Engine removed: with -MP 1-504-
Engine installed: with locking screw ⇒ Chapter 13-2
♦
17 - V-ribbed belt
Routing of the ribbed V-belt ⇒ Fig. 1 in 13-1 page 2
removing ⇒ 13-1 page 4
Edition 02.02
S00.5305.03.20
1
17
16 15
Removing and installing V-ribbed belt
2
5
8
14 13 12
11
13-1
13
3
4
6
7
9
10
S13-0241
1
page