Removing And Installing, Tensioning Toothed Belt - Skoda Octavia 1996 Service Manual

OCTAVIA

Removing and installing, tensioning toothed belt

Note:
Mark the direction of running of the ribbed V-
belt before removing it. If an already used belt
is fitted on again to run in the opposite direction,
it may be destroyed.
1 - Bottom toothed belt guard
♦ unscrew vibration damper before re-
moving ⇒ page 13-1
2 - Center toothed belt guard
3 - 10 Nm
♦ replace
4 - Engine support
♦ removing ⇒ page 13-6
5 - 45 Nm
6 - Top toothed belt guard
7 - Toothed belt
♦ mark direction of running before re-
moving
♦ inspect for wear
♦ do not kink
♦ removing ⇒ page 13-6
♦ installing ⇒ page 13-8
8 - 25 Nm
Edition 10.02
S00.5105.54.20
Crank Assembly
9 - Corrugated washer
10 - 100 Nm
♦ use counterholder MP 1-216 for slack-
ening and tightening
11 - Camshaft sprocket
♦ with sensor rotor for Hall sensor -G40-
♦ removing and installing toothed belt
⇒ page 13-5
♦ fix installation position by means of
parallel key -item. 14-
12 - Toothed belt guard
13 - 10 Nm
14 - Parallel key
♦ Check tightness
15 - Hall sensor -G40-
♦ when bolting on ensure base plate is
centered
16 - 10 Nm
17 - Rear toothed belt guard
18 - 20 Nm
19 - Semi-automatic tensioning pulley
♦ inspecting semi-automatic toothed
belt tensioning pulley ⇒ page 13-10
♦ installation position ⇒ Fig. 1
20 - Coolant pump
♦ removing and installing ⇒ page 19-8
21 - 15 Nm
22 - Crankshaft toothed belt sprocket
♦ there must not be any oil present on
contact surface between toothed belt
sprocket and the crankshaft
♦ assembly is only possible in one posi-
tion
23 - 90 Nm + torque a further
♦ replace
♦ use counterholder T30004 for slack-
ening and tightening or counterholder
MP 1-310 ⇒ page 13-17; removing
and installing front sealing flange.
13
/ turn (90°)
1
4
------------ 13-5 ------------