Removing And Installing Front Exhaust Pipe - Skoda Octavia Workshop Manual

26
¡ ¢
------------ ------------
Exhaust System
Notes:
♦ Always replace gaskets, self-locking nuts
and clamping sleeves.
♦ After carrying out removal and installation
work on the exhaust system, ensure that the
exhaust system is not tensioned and that
adequate clearance exists to the body. If
necessary, slacken clamping sleeve and
align silencer and exhaust pipe so that ad-
equate clearance exists at all points to the
body and the weight of the exhaust system
is evenly distributed over the hangers.
♦ Use a screwdriver to slacken and tighten the
clamping plates for the heat shields. Tight-
ening torque: 2 Nm
♦ Installation position of hangers at tunnel
bridge:
The angled side -arrow- at the base of the
K
hanger points in direction of travel.
Removing and installing front ex-
haust pipe
Special tools, testers and aids required
♦ Torque wrench 5...50 Nm
(e.g. V.A.G 1331)
Removing
K - Take off cover for the plug connection of the
lambda probe and detach electric cable from
the heat shield together with retaining clips
-arrows-.
- Pull plug connection out of the cover and
separate.
OCTAVIA
Edition 08.98
S00.5104.52.20