Removing And Installing The Rear Midrange Speaker; Removing And Installing The Front Midrange Speaker - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
Communication - Edition 04.2019
– Protect socket for MOST-Bus Databus -2- with cover -1-. You
can also use another suitable way (e.g. wrap around a clean
film and tape up).
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– When replacing, code the new control unit with the ⇒ Vehicle
diagnostic tester.
– If the MOST-Bus data bus is damaged, replace databus with
end pieces.
Self-diagnosis of the equipment Soundsystem
Carry out "self-diagnosis" with the ⇒ Vehicle diagnostic tester in
the function "Targeted fault finding".
Specified torques
Component
Fixing screws for the sound system
control unit
2.3 Removing and installing the rear mid‐
range speaker
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by ŠKODA AUTO A. S.
Removing
– Switch off the ignition and all electrical components.
– Remove the door trim panel from which you are removing the
speaker ⇒ General body repairs, interior; Rep. gr. 70 ; Rear
door trim panels; Removing and installing rear door trim .
– Disconnect socket connector at the loudspeaker.
– Take out expanding rivets -arrows- and remove speaker.
Installing
Installation is carried out in the reverse order.
2.4 Removing and installing the front mid‐
range speaker
Removing
– Switch off the ignition and all electrical components.
– Remove the door trim panel from which you are removing the
speaker ⇒ General body repairs, interior; Rep. gr. 70 ; Front
door trim panels; Removing and installing front door trim .
– Disconnect socket connector at the loudspeaker.
16
Rep. gr.91 - Communication
Tightening torque
1.5 Nm