Problem Starting The Flexpendant - ABB IRC5 Operating Manual

3 Troubleshooting by fault symptoms

3.6 Problem starting the FlexPendant

3.6 Problem starting the FlexPendant
Description
The FlexPendant is not responding, either completely or intermittently.
No entries are possible, and no functions are available.
If the FlexPendant starts but does not display a screen image, proceed as detailed
in section
Consequences
The system cannot be operated using the FlexPendant.
Possible causes
The symptom can be caused by (the causes are listed in order of probability):
Recommended actions
The following actions are recommended (listed in order of probability):
1
2
3
4
50
Problem connecting FlexPendant to the controller on page
• The system has not been switched on.
• The FlexPendant is not connected to the controller.
• The cable from the controller is damaged.
• The cable connector is damaged.
• FlexPendant power supply from controller is faulty.
Action
Make sure the system is switched on and
that the FlexPendant is connected to the
controller.
Inspect the FlexPendant cable for any visible
damage.
If possible, test by connecting a different
FlexPendant to eliminate the FlexPendant
and cable as error sources.
If possible, test the FlexPendant with a differ-
ent controller to eliminate the controller as
error source.
© Copyright 2005-2018 ABB. All rights reserved.
Information
How to connect the FlexPendant to the
controller is detailed in Operating manu-
al - Getting started, IRC5 and RobotStu-
dio.
If faulty, replace the FlexPendant.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
51.