ABB IRC5 Operating Manual page 517

112054, Project arg already started
Description
Project arg is already started.
Stop the project, and start it again if the project has been
changed.
Consequences
The execution will continue.
Probable causes
Multiple use of RAPID instruction PmStartProj with the same
project name arg.
Recommended actions
Stop project if the setup has been changed, and start it again.
112055, A project is already started
Description
A project arg is already started. Another project
can not be started until the already started project is stopped.
Consequences
The project arg is not started.
The program execution is immediately halted if the start
order was from RAPID.
Probable causes
Multiple start orders using different project names.
Recommended actions
Check the projects that are started. Remove one of the starts.
112056, Data List Full
Description
Internal data list was full when trying to store the variable arg.
Consequences
Targets depending on this variable will not be executed.
Probable causes
The project is probably too large.
Recommended actions
Reconfigure the project.
112057, Project name is an empty string
Description
The name of the project to start is not valid.
Consequences
Project not started. The program execution is
immediately halted
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
Probable causes
The project name has not been initiated.
Recommended actions
Check the project name used when starting project.
112058, Stop of project ordered during start
Description
A stop order has been received during startup of project arg.
Consequences
Project arg is not started.
Probable causes
Stop during start of project. The stop can be from another client
or
another RAPID task.
Recommended actions
Do not stop project until it has been started correctly.
112059, Ongoing start of project
Description
A start of the project arg is executed right now.
Consequences
If the start order comes from RAPID, the RAPID execution is
immediately stopped.
Probable causes
Start orders from multiple clients or RAPID tasks at the same
time
Recommended actions
Start project only one time.
112060, Stop of project ordered during start
Description
RAPID execution stopped during start of project.
The project arg is not started.
Consequences
RAPID execution is immediately stopped. Project arg is not
started.
Probable causes
A project stop order from PickMaster, FlexPendant, I/O or
RAPID when a
start of a project is executed.
Recommended actions
Try to start project again.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.10 11 xxxx
Continued
517