ABB IRC5 Operating Manual page 532

5 Troubleshooting by event log
5.10 11 xxxx
Continued
Recommended actions
Restarting the controller and starting from the main may resolve
the problem for the next learning cycle.
112513, WDM Signature File Inaccessible
Description
The stored signature could not be written to.
Seam Name: arg
Task: arg
The file may have been left open by another application.
Consequences
Weld Data Monitor is unable to evaluate this weld seam.
Recommended actions
Restarting the controller and starting from the main may resolve
the problem for the next learning cycle.
112514, WDM Results File Inaccessible
Description
The measured results could not be read.
Seam Name: arg
Task: arg
The file may have been left open by another application.
Consequences
Weld Data Monitor is unable to evaluate this weld seam.
Recommended actions
Restarting the controller and starting from the main may resolve
the problem for the next learning cycle.
112515, WDM Data Reading Timeout
Description
Data could not be read from the binary file within a reasonable
time.
Seam Name: arg
Task: arg
Timeout: arg seconds
Consequences
Weld Data Monitor is unable to evaluate this weld seam.
Recommended actions
Delete the stored WDM files and relearn.
112516, WDM Data Checksum Error
Description
Data read from the binary file did not match the expected size.
Seam Name: arg
Continues on next page
532
Task: arg
Consequences
Weld Data Monitor is unable to evaluate this weld seam.
Recommended actions
Delete the stored WDM files and relearn.
112517, WDM Unknown Error
Description
An unexpected error occurred in WriteSigData.
Seam Name: arg
Task: arg
Consequences
Weld Data Monitor is unable to evaluate this weld seam.
Recommended actions
Please report to your ABB representative.
112518, WDM Unknown Error
Description
An unexpected error occurred in EvalSigData.
Seam Name: arg
Task: arg
Consequences
Weld Data Monitor is unable to evaluate this weld seam.
Recommended actions
Please report to your ABB representative.
112519, WDM Signature File Too Short
Description
The end of the signature file was reached before welding
stopped.
Seam Name: arg
Task: arg
Current number of samples: arg
Consequences
Weld Data Monitor is unable to evaluate this weld seam.
112520, WDM File Access Error
Description
Could not open the binary data file described below.
File: arg
Task: arg
The file may have been left open by another application.
© Copyright 2005-2018 ABB. All rights reserved.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA