ABB IRC5 Operating Manual page 531

112503, WDM Failed to Read WDM_SETTINGS
Description
The 'chart' setting in the WDM_SETTINGS section
of the PROC could not be read.
Task: arg
Consequences
Weld Data Monitor not save charting files.
Recommended actions
Please review PROC settings to correct.
112504, WDM Failed to Read WDM_SETTINGS
Description
The IO signal setting in the WDM_SETTINGS section
of the PROC could not be read.
Task: arg
Consequences
Weld Data Monitor will be inoperable.
Recommended actions
Please review PROC settings to correct.
112505, WDM Failed to Read WDM_STABILITY
Description
The WDM_STABILITY section of the PROC could not be found.
Default values have been applied.
Task: arg
112506, WDM Failed to Read WDM_STABILITY
Description
The WDM_STABILITY section of the PROC could not be read.
Task: arg
Consequences
Weld Data Monitor may be inoperable.
Recommended actions
Please review PROC settings to correct.
112507, WDM Failed to Read WDM_SIGNATURE
Description
The WDM_SIGNATURE or WDM_SIGNATURE_DATA section
of the PROC could not be found.
Default values have been applied.
Task: arg
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
112508, WDM Failed to Read WDM_SIGNATURE
Description
The WDM_SIGNATURE or WDM_SIGNATURE_DATA section
of the PROC could not be read.
Task: arg
Consequences
Weld Data Monitor may be inoperable.
Recommended actions
Please review PROC settings to correct.
112509, WDM Failed to Read WDM_TOLERANCE
Description
The WDM_TOLERANCE section of the PROC could not be read.
Task: arg
Consequences
Weld Data Monitor may be inoperable.
Recommended actions
Please review PROC settings to correct.
112510, WDM Learning Results Stored
Description
A learning cycle has finished for arg in task arg
arg of arg learning cycles completed.
Sample size: arg
112511, WDM Learning Complete
Description
Learning is complete for arg in task arg
arg of arg learning cycles completed.
Sample size: arg
Consequences
Monitoring will be active the next time this seam is welded.
112512, WDM Signature File Inaccessible
Description
The stored signature could not be read.
Seam Name: arg
Task: arg
The file may have been left open by another application.
Consequences
Weld Data Monitor is unable to evaluate this weld seam.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.10 11 xxxx
Continued
531