Safety Symbols On Controller Labels - ABB IRC5 Operating Manual

1.3 Safety symbols on controller labels

Introduction to labels
This section describes safety symbols used on labels (stickers) on the controller.
Symbols are used in combinations on the labels, describing each specific warning.
The descriptions in this section are generic, the labels can contain additional
information such as values.
Types of labels
Both the manipulator and the controller are marked with several safety and
information labels, containing important information about the product. The
information is useful for all personnel handling the robot, for example during
installation, service, or operation.
The information labels can contain information in text (English, German, and
French).
Symbols on safety labels
Label
xx1400001151
xx1400001162
xx1400001161
xx1400001160
xx1700000354
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
Note
The safety and health symbols on the labels on the product must be observed.
Additional safety information given by the system builder or integrator must also
be observed.
© Copyright 2005-2018 ABB. All rights reserved.
1.3 Safety symbols on controller labels
Description
Electrical shock
ESD sensitive components inside the controller.
Disconnect power supply before servicing the controller.
Disconnect power supply before servicing the controller (only
for welding equipment).
Disconnect power supply before servicing the controller (for
controllers without UL mains switch).
1 Safety
Continues on next page
19