Configuring Scalable I/O Devices Using The Flexpendant - ABB Scalable I/O Applications Manual

4.4 Configuring Scalable I/O devices using the FlexPendant

General
This section describes the recommended working procedure when installing and
configuring ABB Scalable I/O devices using the FlexPendant.
For information about configuration using RobotStudio, see
I/O devices using RobotStudio on page
Configuring an I/O device
When a base I/O device and an add-on I/O device are connected to the controller,
these must be configured.
Use this procedure to configure a new I/O device on the FlexPendant.
Application manual - Scalable I/O
3HAC070208-001 Revision: F
4.4 Configuring Scalable I/O devices using the FlexPendant
Note
The system should be in manual mode while configuring or updating the I/O
device using the FlexPendant.
Note
Safe digital base devices cannot be configured using the FlexPendant.
1 Start the FlexPendant and connect to the OmniCore controller.
2 On the start screen, tap I/O, and then select I/O Devices from the menu.
3 Select the I/O device and and tap Configure.
xx2100000102
© Copyright 2019-2022 ABB. All rights reserved.
4 Software commissioning
Configuring Scalable
58.
Continues on next page
69