ABB IRC5 Operating Manual page 396

5 Troubleshooting by event log
5.8 7 xxxx
Continued
71536, Device command syntax error
Description
Could not send device command to adapter arg because there
is a syntax error in the command value string.
Device command name arg.
The syntax error: Can't decode arg.
Consequences
The device command was not sent.
Recommended actions
Correct the device command value string.
71537, Invalid configuration data for EtherNet/IP
adapter
Description
The adapter arg has an invalid configuration data. Can't decode
arg at position arg in the configuration data.
Consequences
No communication with the adapter is possible.
Recommended actions
Correct the configuration data for the adapter in the I/O
configuration.
71538, The EtherNet/IP network address must
exist on PC
Description
The given address arg, configured on the EtherNet/IP network,
is not found on any network interface on PC.
Consequences
No communication on the EtherNet/IP network is possible.
Probable causes
The arg address is not configured on any PC network interface.
Recommended actions
Set the arg address on the network interface connected to the
EtherNet/IP network on PC.
71539, Invalid Signal Safe Level
Description
The I/O configuration is invalid.
I/O signal arg has an invalid/unknown Signal Safe Level: arg.
This I/O signal has been rejected.
Recommended actions
Correct the Signal Safe Level for the I/O signal.
Continues on next page
396
71541, Network auto configuration, scan,
successful
Description
The network auto configuration, operation: scan, on network
arg was successful.
Recommended actions
View the information in the Event log.
71542, Network auto configuration, scan, not
successful
Description
The network auto configuration, operation: scan, on network
arg was not successful.
Recommended actions
View the errors in the Event log.
71543, Network auto configuration, scan EDS file,
successful but with warnings
Description
The network auto configuration, operation: scan EDS file(s), on
network arg and file arg was successful but with warnings.
Consequences
The Template Device arg might not be complete.
Probable causes
Internal info:
arg
arg
Recommended actions
Verify the Template Device arg. Invalid parameters has to be
manually corrected.
71544, Network auto configuration, scan EDS file,
not successful
Description
The network auto configuration, operation: scan EDS file(s), on
network arg and file arg was not successful.
Consequences
No Template Device could be created from the file arg.
Probable causes
Internal info:
arg
arg
arg
© Copyright 2005-2018 ABB. All rights reserved.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA