ABB IRC5 Operating Manual page 251

Program ref: arg.
Recommended actions
Check the file path and the file name. Check if the file exists.
Recovery: arg.
40703, Unload Error
Description
Task: arg.
The program module could not be unloaded. The reason is that
the module is changed but not saved.
Program ref: arg.
Recommended actions
The instruction UnLoad: Use the optional switch ErrIfChanged,
without recover from this situation, in an Error handler.
Recovery: arg.
40704, UnLoad Error
Description
Task: arg.
arg. The program module couldn't be unloaded.
Program ref: arg.
Probable causes
Module not loaded with Load instr. Not same file path as used
for Load.
Recommended actions
Check if the program module has been loaded with the
instruction Load. Check if the file path and name are the same
in the UnLoad and Load instruction. Recovery: arg.
40705, Syntax Error
Description
Task: arg.
Syntax error arg.
Recommended actions
More syntax errors will follow this.
40706, Load Error
Description
Task: arg.
The program module is already loaded.
Program ref: arg.
Probable causes
The module name in the head of the file arg already exists in
the program memory.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
Recommended actions
Recovery: arg.
40707, I/O Device Name Invalid
Description
Task: arg.
The I/O device name arg does not exist.
Program ref: arg.
Recommended actions
Check if the I/O device name is misspelled. Check if the I/O
device is defined. Recovery: arg.
40708, I/O Device Is Not Enabled
Description
Task: arg.
I/O device arg was not enabled.
Program ref: arg.
Probable causes
The maximum period of waiting time was too short.
Recommended actions
Increase the waiting time or make a retry.
Recovery: arg.
40709, I/O Device Is Not Deactivated
Description
Task: arg.
I/O device arg was not deactivated.
Program ref: arg.
Probable causes
The maximum period of waiting time was too short.
Recommended actions
Increase the waiting time or make a retry.
Recovery: arg.
40710, Argument Error
Description
Task: arg.
The argument arg is an expression value, is not present or is
of the type switch.
Program ref: arg.
Recommended actions
Change the parameter arg to a valid one.
Recovery: arg.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.6 4 xxxx
Continued
251