ABB IRC5 Operating Manual page 550

5 Troubleshooting by event log
5.12 13 xxxx
Continued
device. The range of curve is modified
due to modified range of regulator.
Recommended actions
133253, arg:Resizing
Description
IPS has resized a dynamic or
calibrated curve, number arg, for named
device. Due to change in curvesize
parameter, the existing curves are
transformed to the new curvepoint size.
Recommended actions
133254, arg:DMC error
Description
IPS has lost communication or
discovered an error sent from named
DMC-driver.
DMC error code is: arg.
Recommended actions
1. Check DMC-driver status LEDs.
2. Check power supply on the DMC-driver.
3. Turn off and on the DMC-driver power.
133255, Apmb error
Description
IPS has discovered an Apmb-driver
(Berger-Lahr driver) error.
Apmb-driver, number: arg, has issued an
error.
Recommended actions
1. Check the fault LEDs codes on the
Berger-Lahr Drive unit.
2. Check stepper motor.
3. Check wiring for Berger-Lahr driver.
133256, arg:Curve err
Description
IPS has discovered a number
format on named dynamic/calibrated
curve that is not correct.
Recommended actions
1. Check if an already saved curve on
the IPS node has an incompatible number
Continues on next page
550
format than expected.
2. Delete the saved curve on the
IPS board.
133257, SDI error
Description
SDI board have issued following
error:arg,
with error code:arg.
Recommended actions
1. Check SDI board for errors.
133258, VCD error,MacID:arg
Description
IPS has discovered an error
on a VCD board with following
details:arg.
Recommended actions
1. Check VCD board for the error reason
given.
2. Replace the VCD board.
133259, File Access Error
Description
IPS has discovered a File Access
Error on following file: arg.
Recommended actions
1. Check if named file exists.
2. Check if file is currently in use.
133260, File Defaulted
Description
IPS has created a default file
of type: 'arg' with
following file name: arg.
Recommended actions
133261, File Parse Error
Description
IPS failed to load the following file arg in line arg.
Detailed error text: arg.
Recommended actions
1. Check that named file has the correct format for its use.
© Copyright 2005-2018 ABB. All rights reserved.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA