ABB IRC5 Operating Manual page 393

71509, Device command syntax error
Description
Could not send device command to I/O device arg because
there is a syntax error in the command path string.
Device command name arg.
The syntax error: Missing space.
Consequences
The device command was not sent.
Recommended actions
Correct the device command path string.
71510, Device command syntax error
Description
Could not send device command to I/O device arg because
there is a syntax error in the command path string.
Device command name arg.
The syntax error: Incorrect byte size.
Consequences
The device command was not sent.
Recommended actions
Correct the device command path string.
71511, Device command syntax error
Description
Could not send device command to I/O device arg because
there is a syntax error in the command path string.
Device command name arg.
The syntax error: Incorrect data size.
Consequences
The device command was not sent.
Recommended actions
Correct the device command path string.
71512, Invalid service identifier in device
command
Description
Could not send device command to I/O device arg because of
invalid service identifier arg.
Valid service identifiers are:
arg.
Recommended actions
Correct the service identifier.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
71513, Device command response timeout
Description
A timeout occurred when sending device command arg to the
I/O device arg.
Consequences
The device command was not sent.
Recommended actions
Check the device command syntax. Make sure that the network
cable is connected to the controller.Make sure the I/O device
has is correctly powered. Make sure the cabling to the I/O device
is correctly connected.
71514, Device command connection error
Description
Could not send device command arg to the I/O device arg
because no active connection was present.
Consequences
The device command was not sent.
Recommended actions
Check the device command syntax. Make sure that the network
cable is connected to the controller.Make sure the I/O device
has is correctly powered. Make sure the cabling to the I/O device
is correctly connected.
71515, Device command send error
Description
Could not send device command arg to the I/O device arg.
arg.
Consequences
The device command was not sent.
Recommended actions
Check the device command syntax. Make sure that the network
cable is connected to the controller.Make sure the I/O device
has is correctly powered. Make sure the cabling to the I/O device
is correctly connected.
71516, An EtherNet/IP adapter does not support
Quick Connect
Description
The adapter arg does not support Quick Connect.
Recommended actions
Set the parameter Quick Connect to "Not used" for the adapter
in the I/O configuration. Restart the controller.
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.8 7 xxxx
Continued
393