ABB IRC5 Operating Manual page 296

5 Troubleshooting by event log
5.6 4 xxxx
Continued
Recommended actions
Remove some subscriptions on signals or change the time for
the event. (i.e. any ISignalXX or TriggIO).
41683, Argument Error
Description
Task: arg.
The argument arg must be given when searching for a not
named parameter.
Program ref: arg.
Recommended actions
Add the parameter arg to the instruction.
41684, Value Error
Description
Task: arg.
The argument arg is outside the range of value type unsigned
long.
Program ref: arg.
Probable causes
The value is too large.
Recommended actions
Use a smaller value for arg.
41685, Not valid value
Description
Task: arg.
A wrong combination of switch and value is used. The signal
can have values between:
Min: arg.
Max: arg.
Switch and value used: arg.
Program ref: arg.
Consequences
The program execution is stopped immediately.
Probable causes
Wrong value used, or wrong switch used.
Recommended actions
Change the value used, or change the switch argument.
41687, File Open Error
Description
Task: arg.
Unable to open arg.
Continues on next page
296
Program ref: arg. An unknown error occurred while opening
the file.
Probable causes
If the file was located on an USB disk, check that the disk is
not removed, or has too many files in root folder. Check that
the given file is not a directory.
Recommended actions
Do a check of Probable Causes.
Recovery: arg.
41688, Invalid Argument
Description
Task: arg.
Inparameter arg is declared as a PERS.
Program ref: arg.
Consequences
The program execution is stopped immediately.
Probable causes
Using a PERS in argument arg to instruction arg.
Recommended actions
Replace the PERS with a valid argument.
41690, Parameter Error
Description
Task: arg.
The argument arg is of the type arg and is not valid to use.
Program ref: arg.
Consequences
The program execution is stopped immediately.
Recommended actions
Check the data type. Non-value, semi-value types or motsetdata
data type cannot be used.
41691, RMQ Error - Client name not valid
Description
Task: arg.
The name arg cannot be found. It is not a valid RMQ client
name.
Program ref: arg.
Probable causes
A non-valid name is used.
Recommended actions
Change name to search for.
© Copyright 2005-2018 ABB. All rights reserved.
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA