ABB IRC5 Operating Manual page 461

Line: arg.
Recommended actions
Check the program.
110212, Application error
Description
Task: arg
arg tried to use a non existent process descriptor.
A fatal error in damastr class.
arg
Probable causes
The XXShPowerOn has not been executed.
Recommended actions
Check if XXShPowerOn was done.
110214, Application error
Description
Task: arg
arg tried to use a non existent application descriptor.
arg
Probable causes
The XXShPowerOn has not been executed, or to few DA_PROC
task are specified.
Recommended actions
Check if XXShPowerOn was done.
If using only DAP you should save a sys.cfg, and add a new
DA_PROCX task in that file. Check what files are loaded for
DA_PROC1 task and add them to your new task.
110216, Application error
Description
Task: arg
Attempt to install a process number
outside it's limits.
arg
arg
Recommended actions
Check the program, max number of processes are limited to 4.
110220, Application error
Description
Task: arg
The user data variable choice does not exist.
arg
Operating manual - Troubleshooting IRC5
3HAC020738-001 Revision: AA
arg
110221, Application error
Description
Task: arg
The user data variable has incorrect type.
arg
arg
110222, Application error
Description
Task: arg
The internal process data type lacks daintdata as first element.
arg
arg
Recommended actions
Check the program.
110223, Application error
Description
Task: arg
The user data type definitions exceed the maximum data
storage size.
arg
arg
Recommended actions
Check the program.
110224, Application error
Description
Task: arg
The user data type definitions does not correspond to what was
defined.
arg
arg
110226, Application error
Description
Task: arg
An error occurred while attempting to reload the Power Failure
area.
An automatic restart of the processes will not be possible.
arg
arg
© Copyright 2005-2018 ABB. All rights reserved.
5 Troubleshooting by event log
Continues on next page
5.10 11 xxxx
Continued
461