Subaru IMPREZA GD 2007 Series Manual page 1984

asieps_tobira_IM_US.book 193 ページ ２０１２年１月１７日 火曜日 午後３時４８分
Diagnostic Trouble Code (DTC) Detecting Criteria
CQ:DTC P0851 NEUTRAL SWITCH INPUT CIRCUIT LOW (MT MODEL)
1. OUTLINE OF DIAGNOSIS
Judge the open or short circuit of the neutral SW.
Judge as NG when there is no change in the neutral SW even if the driving shift was applied. (There is neutral
SW ON/OFF inversion from the vehicle speed and engine speed.)
2. ENABLE CONDITION
Secondary Parameters
Ignition switch
Battery voltage
After engine starting
Starter switch
3. GENERAL DRIVING CYCLE
Perform the diagnosis continuously in two seconds after starting the engine.
4. DIAGNOSTIC METHOD
Judge as NG when the malfunction criteria below are completed three times or more after the neutral SW
change. And clear NG if there is change in the neutral SW.
Judgment Value
Malfunction Criteria
Neutral switch signal (while changing
from a to b below)
Driving condition change
a) Vehicle speed = 0 km/h (0 MPH) &
engine speed 600 — 900 rpm
b) Vehicle speed ≥ 64 km/h (40 MPH) &
engine speed 1,600 — 2,550 rpm
Time Needed for Diagnosis: 3 monitorings
Malfunction Indicator Light Illumination: Illuminates when malfunction occurs in two continuous driving
cycles.
5. DTC CLEAR CONDITION
• When the OK idling cycle is completed 40 times in a row
• When "Clear Memory" is performed
6. MALFUNCTION INDICATOR LIGHT CLEAR CONDITIONS
• When the OK driving cycle is completed three times in a row
• When "Clear Memory" is performed
7. FAIL SAFE
Cruise control: Not allowed to command cruise control.
8. ECM OPERATION AT DTC SETTING
Memorize the freeze frame data. (For test mode $02)
Enable Conditions
ON
≥ 10.9 V
2 seconds or more
OFF
Threshold Value
Low continues
a) to b)
GD(H4DOTC)-193
GENERAL DESCRIPTION