Toyota Tundra 2005 Service - Repair - Maintenance page 1800

Hide thumbs Also See for Tundra 2005:
Table of Contents

Advertisement

ENGINE MECHANICAL (2UZ−FE)
Connect
A09152
ENGINE UNIT (4WD)
6.
CONNECT ENGINE WIRE TO CABIN
(a)
Push into the engine wire through the cowl panel.
(b)
Install the engine wire bracket with the 2 nuts and bolt and
connect the engine wire to the bracket.
(c)
Connect the 3 connectors to the ECM.
(d)
Connect the 2 wire harness connectors (cassette con-
nector).
(e)
Install the ECM with the 3 screws.
(f)
Install the lower No. 2 panel.
(g)
Install the glove compartment door.
7.
INSTALL FAN PULLEY, FAN, FLUID COUPLING AND
DRIVE BELT
(a)
Temporarily install the fan pulley, the fan and fluid cou-
pling assembly with the 4 nuts.
(b)
Install the drive belt (See page
(c)
Tighten the 4 nuts holding the coupling to the fan bracket.
8.
INSTALL BATTERY CABLES
(a)
Connect the battery positive (+) terminal cable.
(b)
Connect the battery negative (−) cable to the battery and
left fender apron.
(c)
Connect the clamp on battery negative (−) cable to No. 2
relay box.
9.
INSTALL AIR CLEANER AND INTAKE AIR CONNEC-
TOR PIPE ASSEMBLY
(a)
Install the air cleaner case with the 3 bolts.
Torque: 5 N·m (51 kgf·cm, 44 in.·lbf)
(b)
Connect the intake air connector to the throttle body.
(c)
Connect the MAF meter connector.
(d)
Install the A/C suction hose to the intake air connector.
(e)
Connect the PS air hose, air inlet hose for EVAP, PCV
hose and MAF meter connector to the intake air connec-
tor.
10.
INSTALL THROTTLE BODY COVER
11.
INSTALL TRANSMISSION (See page AT−38)
12.
INSTALL RADIATOR ASSEMBLY (See page CO−18)
13.
INSTALL FRONT STABILIZER BAR
(See page SA−91)
14.
INSTALL FRONT AND REAR PROPELLER SHAFTS
(See page PR−15)
15.
INSTALL FRONT EXHAUST PIPES
(See page EM−125)
16.
FILL WITH ENGINE COOLANT (See page CO−2)
17.
FILL WITH ENGINE OIL (See page LU−2)
18.
START ENGINE AND CHECK FOR LEAKS
19.
INSTALL ENGINE UNDER COVERS
20.
INSTALL HOOD
21.
PERFORM ROAD TEST
Check for abnormal noise, shock, slippage, correct shift points
and smooth operation.
22.
RECHECK ENGINE COOLANT AND OIL LEVELS
EM−97
CH−16
or CH−28).

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tundra 2006

Table of Contents