Delay-Restore - Dell C9000 Series Reference Manual

Version
9.0.0.0
8.3.19.0
8.3.12.0
Example
Dell(conf-vlt-domain)#do clear vlt statistics
Sure want to Clear VLT Statistics
Dell(conf-vlt-domain)#
Related show vlt statistics
Commands

delay-restore

Configure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT peer
switches.
C9000 Series
Syntax
delay-restore
Parameters
delay-restore
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
Description
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
— displays statistics on VLT operations.
Enter the amount of time, in seconds, to delay bringing up the
VLT ports after the VLT device is reloaded or after the peer-link
is restored between VLT peer switches. The range from 1 to
1200. The default is 90 seconds.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
[confirm] yes
Virtual Link Trunking (VLT) 2207