Dell C9000 Series Reference Manual page 2203

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.12.0
8.4.2.3
Usage Information You can assign physical port or port-channel interfaces to an uplink-state group.
You can assign an interface to only one uplink-state group. Configure each interface
assigned to an uplink-state group as either an upstream or downstream interface, but
not both.
You can assign individual member ports of a port channel to the group. An uplink-state
group can contain either the member ports of a port channel or the port channel itself,
but not both.
Example
Dell(conf-uplink-state-group-16)# upstream tengigabitethernet
1/10-15
Dell(conf-uplink-state-group-16)#
Related
•
Commands
•
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
downstream — assigns a port or port-channel to the uplink-state group as a
downstream interface.
uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
Uplink Failure Detection (UFD) 2203