System And General Operation - YASKAWA NX100 Operator's Manual

11 Error
11.1 Error Message List
11.1.1

System and General Operation

Error No. Data
Turn off servo power and perform
10 -
corrective action
20 - Depress TEACH
30 - Illegal setting for number of variables
40 - Undefined robot position variables
Undefined points (ORG, XX, XY)
60 -
Program and current tool different
70 -
80 - Same position in the 3 points
100 - On overrun recovery status
110 - Turn ON servo power
120 - Set to PLAY mode
130 - No start using external signal
140 - No start using P.P.
180 - TEACH mode select signal ON
190 - Set variable number
200 - Defined group axis
210 - Undefined coordinated robots
212 Cannot register group combination
230 - While releasing soft limit
240 - Undefined robot
270 - Undefined gun condition file
280 - Lack of number of I/O points
290 - Cannot set same No.
300 - Undefined user frame
310 - Cannot register Master JOB
320 - Cannot operate CHECK-RUN
330 - Cannot operate MACHINE LOCK
Error Message
11-2
Contents
It cannot be operated while servo
power supply is ON.
Out of specified operation mode
Parameter setting error
Position variable cannot be used.
Not registered user coordinates
basic 3 points (ORG, XX, XY)
The tool number registered with
teaching position data does not
match the tool number selected at
the programing pendant.
RE-CSO-A031
149235-1CD
478 of 493