Step" - YASKAWA NX100 Operator's Manual

149235-1CD
S2C170: PLAYBACK EXECUTION AT CYCLE MODE "1- STEP"

Parameter Setting
Value
When operating "FORWARD" by the programming pendant, the units for execution are set
NOTE
in another parameter (S2C150).
S2C171: EXTERNAL START

This parameter specifies whether a start instruction from external input is accepted or not. The
specification can be done on the OPERATING CONDITION window.
0: Permitted
1: Prohibited
 S2C172: PROGRAMMING PENDANT START
This parameter specifies whether a start instruction from the programming pendant is accepted or not.
0: Permitted
1: Prohibited
 S2C173: SPEED DATA INPUT FORM
This parameter specifies the units for speed data input and display.
mm/s : in units of 0.1 mm/s
cm/min : in units of 1cm/min
inch/min : in units of 1 inch/min
mm/min : in units of 1 mm/min
The specification can be done on the OPERATING CONDITION window.
0: mm/sec
1: cm/min
2: inch/min
3: mm/min
MOVL
DOUT
TIMER
0
DOUT
MOVL
MOVL
DOUT
TIMER
1
DOUT
MOVL
8-16
8.3 Mode Operation Setting Parameters
Operation Units
Stops at every instruction.
Stops at move instruction.
8 Parameter
305 of 493
RE-CSO-A031