Selecting Welding Condition Files - YASKAWA NX100 Operator's Manual

149235-1CD
9.5.2

Selecting Welding Condition Files

There are two types of the welding start/end condition file: standard type and enhanced type.
To change the type of a welding condition file, perform the setting following the procedures below.
When the type of the file changes, the welding start/end condition file is initialized.
NOTE
To load a welding condition file that has been saved on an external memory device, files
that are different type than those being used cannot be loaded. Load files of the same
type.
Change the setting of the welding condition files in the management mode.
SUPPLE
In the operation mode or editing mode, the setting status can be only referred to.
-MENT
Operation
1 While pressing [MAIN MENU],
turn ON the power.
2 Change the security mode to
the management mode.
3 Select {SYSTEM} from the
main menu.
4 Select {SETUP}.
5 Select "OPTION FUNCTION." The OPTION FUNCTION window appears.
SECURITY
SYSTEM
SETUP
FILE
VERSION
SECURITY
TOOL
CF
DISPLAY SETUP
A a
Main Menu ShortCut
The SETUP window appears.
DATA EDIT
SETUP
LANGUAGE
CONTROL GROUP
APPLICATION
IO MODULE
OPTION BOARD
CMOS MEMORY
DATE/TIME
OPTION FUNCTION
EDIT
DATA
OPTION FUNCTION
ARC WELDING
9-44
9 Arc Welding Application
9.5 Welding Condition Files
Explanation
! Turn on servo power
DISPLAY UTILITY
DISPLAY UTILITY
STANDARD
387 of 493
RE-CSO-A031