YASKAWA NX100 Operator's Manual page 159

149235-1CD
Automatic Setting for Operation Cycle
Automatic setting of the operation cycle can be changed by the following operation.
This can be done in the management mode only.
Operation
1 Select {SETUP} under the
main menu.
2 Select {OPERATE COND}.
3 Select desired operation.
The OPERATING CONDITION window appears. Use the cursor
to scroll the screen.
DATA EDIT DISPLAY
OPERATING CONDITION
MASTER JOB CHANGE
RESERVED START
RESERVED START JOB CHANGE
SPEED DATA INPUT FORM
CYCLE SWITCH IN TEACH MODE
CYCLE SWITCH IN PLAY MODE
CYCLE SWITCH IN LOCAL MODE
CYCLE SWITCH IN REMOTE MODE
SET CYCLE ON POWER ON
Main Menu Short Cut
The selection dialog box appears.
DATA EDIT DISPLAY
OPERATING CONDITION
MASTER JOB CHANGE
RESERVED START
RESERVED START JOB CHANGE
SPEED DATA INPUT FORM
CYCLE SWITCH IN TEACH MODE
CYCLE SWITCH IN PLAY MODE
CYCLE SWITCH IN LOCAL MODE
CYCLE SWITCH IN REMOTE MODE
SET CYCLE ON POWER ON
Main Menu Short Cut
"NONE" setting
SUPPLE
-MENT
The operation cycle is not changed when "NONE"
is set.
For example, if the setting is "CYCLE SWITCH IN
TEACH MODE = NONE," the operation cycle after
selecting the teach mode is the same as the one
before.
4-7
4.1 Preparation for Playback
Explanation
UTILITY
PERMIT
PROHIBIT
PERMIT
cm/min
1 CYCLE
1 CYCLE
1 CYCLE
1 CYCLE
1 CYCLE
UTILITY
PERMIT
PROHIBIT
PERMIT
cm/min
1 CYCLE
STEP
1 CYCLE 1 CYCLE
CONTINUOUS
1 CYCLE
NONE
1 CYCLE
1 CYCLE
RE-CSO-A031
4 Playback
159 of 493