Registering A Job - YASKAWA NX100 Operator's Manual

3 Teaching
3.1 Preparation for Teaching
3.1.3

Registering a Job

Specify the name, comments (as required), and control group to register a job.
 Registering Job Names
Job names can use up to 8 alphanumeric and symbol characters. These different types of characters
can coexist within the same job name.
The following rules apply to the designation of names for reserved jobs:
A maximum of six characters can be used for a reserved job name.
When a reserved job name is used, additional characters are added by the system.
<Example>
Operation
1 Select {JOB} under the main
menu.
2 Select {CREATE NEW JOB}.
3 Input job name.
4 Press [ENTER].
0 0 1 JOB - 1
The sub-menu appears.
JOB
ARC WELDING
VARIABLE
B001
IN/OUT
In
ROBOT
SYSTEM INFO
Main Menu
The NEW JOB CREATE window appears.
JOB
NEW JOB CREATE
JOB NAME
COMMENT
GROUP SET
EXECUTE
Main Menu
Move the cursor to JOB NAME, and press [SELECT]. Input job
names using the character input operation. For information on
character input operation, refer to section 1.2.6 "Character Input".
3-2
WORK - A
Explanation
EDIT DISPLAY UTILITY
FD/CF
JOB
DOUT
JOB
MOVE
END
DOUT
MOVE
CF
END
SETUP
SELECT JOB
CREATE NEW JOB
DISPLAY SETUP
A a
MASTER JOB
Out
JOB CAPACITY
CYCLE
Short Cut
EDIT DISPLAY UTILITY
R1
CANCEL
Short Cut
149235-1CD
66 of 493
RE-CSO-A031