S2C298: Variable Name Alias Function - YASKAWA NX100 Operator's Manual

8 Parameter
8.3 Mode Operation Setting Parameters


S2C298: VARIABLE NAME ALIAS FUNCTION

On the JOB CONTENT window, the name registered to the variable (including local variables) can be
displayed as alias instead of the variable number.
Parameter Setting Value
With this function valid, the confirmation dialog box "Register by name (alias)?" is displayed when you
select the variable on the DETAIL EDIT window. Select "YES" and the variable select window appears.
Then select the target variable of number and press [ENTER], and the registered name is displayed
instead of the variable number. However, if the variable number's name is not yet registered, it is
displayed by number as usual.
<Example> Registration of the byte type variable B000 as "WORK KIND"
In the case of SET instruction
S2C298=0 : SET B000 128
S2C298=1 : SET WORK KIND 128
Select {VARIABLE} from the menu to select each variable and edit the variable name. Up
to 16 characters can be entered as a variable name. However, when this function is valid, if
the content below is entered, the error message shows and the name cannot be
SUPPLE
-MENT
registered.
•
The name already registered
• Letters beginning with a number
• Letters including the signs below:
• ( , ) , [ , ] , = , < , > , space, comma
• Letters beginning with "alphabets representing variables" + "number"
<Example> B0..., I0..., BP1..., LEX2...
When the name begins with " ' ", it is regarded as a comment and the same comment can
be registered for two or more variables. In this case, although this function is valid, the
number is displayed on the JOB CONTENT window instead of the name.
<Example> Registration of the byte type variable B001 as "WORKNUM"
S2C298
0 Function invalid
1 Function valid
Alphabets representing variables: B, I, D, R, S, P, BP, EX, PX,
LB, LI LD, LR, LS, LP, LBP, LEX, LPX
S2C298=0 : SET B001 10
S2C298=1 : SET B001 10
8-21
Valid/Invalid
149235-1CD
310 of 493
RE-CSO-A031