Error Message List - YASKAWA NX100 Operator's Manual

149235-1CD
11 Error

11.1 Error Message List

Error warns the operator not to advance to the next operation caused by a wrong operation or the
access method when using the programming pendant or an external equipment (computer, PLC, etc.).
When an error occurs, confirm the content of the error then release the error.
To release the error, perform either of the following operations:
• Press [CANCEL] on programming pendant.
• Input alarm/error reset signal (system input).
An error is different from an alarm because it does not stop the robot even if it occurred
NOTE
while the robot was operated (during playback).
Main Menu ShortCut
Cannot insert/modify/delete for axis detachment
11-1
11 Error
11.1 Error Message List
477 of 493
RE-CSO-A031