Enhanced Welding Condition File Function - YASKAWA NX100 Operator's Manual

9 Arc Welding Application
9.4 Registering Arc Welding Instructions
9.3.9

Enhanced Welding Condition File Function

The enhanced welding condition file function improves the method of setting the welding condition file.
This function can be used as follows:
• Changing the welding start condition to the main condition can be performed during
manipulator operation using the enhanced arc start condition file.
• The crater processing can be set to two stages using the enhanced arc end condition file.
• Analog output to the Power Source increases by 2 channels. Therefore, Power Sources
with polarity ratio control can be used.
Enhanced Welding Condition File
NOTE
Parameter setting is necessary to use the enhanced welding condition file.
(Refer to section 9.5.2 "Selecting Welding Condition Files".)
Select either the standard welding condition file or the enhanced welding condition file as
for the welding condition file.
9.4
Registering Arc Welding Instructions
9.4.1
ARCON
This is the instruction to turn ON the arc start signal to the Power Source to start welding.
The function key [ARCON] can be used for registration.
8 Function key to register the welding start instruction (ARCON)
ARCON
To register the ARCON instruction using [INFORM LIST], select "DEVICE" from the
SUPPLE
instruction group list.
-MENT
Registering the ARCON Instruction

Operation
1 Press [ARCON].
2 Press [ENTER].
Explanation
9-13
149235-1CD
356 of 493
RE-CSO-A031