Configure A Simple Test - Keithley 4200A-SCS Reference Manual

Model 4200A-SCS Parameter Analyzer Reference Manual

Configure a simple test

Use the Configure pane to set up your test. For interactive test modules (ITMs), the Configure pane
displays a schematic of the test device. The schematic is connected to an object that shows the
operation mode and the type of instrument that is connected to the terminal.
The software connections must accurately reflect the physical hardware connections when the test is
executed. Incorrect terminal configurations can result in anomalous test results and device damage.
The key parameters for each terminal are displayed near the terminal. The key parameters include:
•
The type of terminal, such as gate, drain, source, or collector.
•
The instrument that is attached to the terminal. You assign the instrument, ground unit, or open
circuit that is physically connected to the terminal during the test.
•
The operation mode and basic settings for that mode. For example, the start and stop values are
displayed if a sweep operation mode is selected.
For user test modules (UTMs), the display depends on the settings of the user module that the UTM
is based on.
4200A-901-01 Rev. C / February 2017
Figure 220: Configure pane
Section 6: Clarius
6-13