Rep 16.2.8 Stacker Upper Cover; Rep 16.2.9 Stack Height Sensors 1 And 2 - Xerox WorkCentre 5222 Service Manual

REP 16.2.8 Stacker Upper Cover

Parts List on PL 23.7
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the Stacker Tray. (REP 16.2.16)
2. Remove the Stacker Lower Cover.
3. Remove the Screws (6). (Figure 1)
4. Remove the Stacker Upper Cover.
Stacker Upper Cover
Screw (6)
Figure 1 Removing the Stacker Upper Cover (j0st41700)
Replacement
1. Reverse the removal procedure for replacement.
Repairs and Adjustments
REP 16.2.8, REP 16.2.9
WARNING
(REP 16.2.7)

REP 16.2.9 Stack Height Sensors 1 and 2

Parts List on PL 23.11
Removal
To avoid personal injury or shock, do not perform repair or adjustment with electrical
power applied to the machine.
1. Remove the Rear Upper Cover.
2. Remove the Stack Height Sensor 1 or 2.
a. Disconnect the connector.
b. Remove the Sensor.
Stack Height Sensor 1
Figure 1 Removing the Stack Height Sensor 1 or 2
February, 2008
4-140
WARNING
(REP 16.2.3)
(Figure 1)
Stack Height Sen-
sor 2
WorkCentre 5225, 5230
1
Discon-
nect the
connec-
tor
2
Remove
the Sen-
sor
Launch Version