Rep 13.19 Stacker Elevator Motor - Xerox VersaLink B7025 Service Manual

Replacement
1. The replacement is the reverse of the removal procedure.
2. Ensure the locating pins (1) are correctly engaged,
Figure 2 Crease assembly
3. Perform ADJ 13.2 Finisher LX Booklet Crease/Staple Position.
Launch Issue
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
Figure 2.
April 2017
4-117

REP 13.19 Stacker Elevator Motor

Parts List on PL 13.15
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the finisher rear upper cover,
2. Disconnect PJ8988 on the finisher control PWB.
3. Release the harness from the clamps.
4. Remove the wires from the wire guide, remove two screws, then move the wire guide to
one side.
5. Use a 5.5 mm combination wrench to remove both screws from the motor mount.
6. Remove the stacker elevator motor.
Replacement
The replacement is the reverse of the removal procedure.
WARNING
GP 10. Disconnect the power cord
REP 13.7.
Repairs and Adjustments
REP 13.18, REP 13.19