Rep 12.19-171 Bm Crease Roll Motor - Xerox ColorQube 9303 Series Service Manual

8. Figure 2, remove the BM crease blade motor.
3
Remove the sensor
from the bracket.
Figure 2 Removing the motor
Replacement
Reverse the removal procedure to replace the BM crease blade motor.
NOTE: Ensure that the mark on the crease blade knob aligns with the arrow on the front infill
cover when the crease blade is fully withdrawn.
Repairs/Adjustments
REP 12.18-171, REP 12.19-171

REP 12.19-171 BM Crease Roll Motor

Parts List on
Removal
Take care during this procedure. Sharp edges may be present that can cause injury.
Switch off the electricity to the machine
tomer supply while performing tasks that do not need electricity. Electricity can cause
death or injury. Moving parts can cause injury.
1.
1
2.
Support the encoder
and slide out the
shaft.
2
Remove the
encoder.
February 2013
4-146
PL 12.175.
WARNING
WARNING
GP
Remove the top cover, then the rear cover,
Remove 4 screws securing the BM PWB mounting plate to the frame, allow the PWB and
mounting plate to hang down, giving access to the BM crease roll motor.
14. Disconnect the power cord from the cus-
REP 12.1-171.
ColorQube® 9303 Family