Connecting To Cc-Link Module (Q Series) With Ver.2 Compatible - Mitsubishi Electric GOT2000 Series Connection Manual

12.4.6

Connecting to CC-Link module (Q Series) with Ver.2 compatible

This section describes the settings of the GOT and CC-Link module (Q Series) in the following case of system configuration.
■1. System configuration
*1 The CC-Link module is mounted on the base unit slot 0.
The Start I/O No. of the CC-Link module is set to "0"
POINT POINT POINT
CC-Link module (Q Series)
For details of the CC-Link module (Q Series), refer to the following manual.
➠
CC-Link System Master/Local Module User's Manual QJ61BT11N
*1
<CC-Link module>
(Use the default value for the settings other than the following.)
Type : Master station
Station No. : Station No.0
Mode : Remote net (Ver.2 mode)
All connect count : 1
Transmission speed : 156kbps
POINT POINT POINT
When connecting to Q170MCPU or Q170MSCPU(-S1)
When connected to Q170MCPU or Q170MSCPU(-S1), the start I/O No. of the CC-Link module is
set to "70".
<GOT>
(Use the default value for settings other
than the following.)
Station No. : Station No.1
Expanded cyclic setting : Single
Number of
: Exclusive station 1
stations occupied
Transmission speed : 156kbps
12.4 PLC Side Setting
12
12 - 35