Mitsubishi Electric GOT2000 Series Connection Manual page 674

(b) Station information setting
Station type
Exclusive station count
Reserve/invalid station select
Intelligent buffer select (word)
*1
*2
■4. Parameter setting (when connecting to C Controller module (Q Series))
Use SW3PVC-CCPU-E Ver.3.05F or later for the CC-Link utility.
(1) Connection settings
*1
Target module
Write authority
*2
User name
*2
Password
Detailed settings
*1
*2
12 - 32
12.4 PLC Side Setting
*1
Item
*2
When the [Mode] of the CC-Link module is set at [Remote net - (Ver. 1 mode)], [Remote station points] cannot be set.
Set the same number of occupied stations as that on the GOT.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU, operate the PLC CPU ether turning OFF
and then ON or resetting.
Item
If the IP address of the C Controller module (Q Series) has been changed, input the changed IP address or host name.
If the account of the C Controller module (Q Series) has been changed, input the changed user name and password.
Set value
Intelligent device station (fixed)
Exclusive station 1
No setting
(Use default value)
: Necessary : As necessary
Set value
192.168.3.3 (Default)
Mark the checkbox
target
password
-
: Necessary : As necessary
Setting necessity
at GOT connection
: Not necessary
Setting necessity at GOT
connection
: Not necessary