Mitsubishi Electric GOT2000 Series Connection Manual page 656

For details of the hardware test, refer to the following manual.
➠
*2 In the case of MELSEC iQ-F series or MELSEC-FX, Transmission method is set to "cyclic".
12 - 14
12.3 GOT Side Settings
Set value
D
E
CC-Link System Master/Local Module User's Manual for CC-Link module to be used
POINT POINT POINT
(1) Communication interface setting by Utility
The communication interface setting can be changed on the Utility's [Communication
Settings] after writing [Controller Setting] of project data.
For details on the Utility, refer to the following manual.
➠ GOT2000 Series User's Manual (Utility)
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
(3) Indirect specification of the servo axis No.
When the servo axis No. is specified to 100 to 115 in GT Designer3, the servo axis number
can be indirectly specified using the 16-bit GOT internal data register (GD device).
Set the head No. of the GOT internal data register (GD device) to be used when indirectly
specifying as "Servo axis switching GD device head No."
When the set value of "Servo axis switching GD device head No." is "10", the values of GD10
to GD25 are servo axis numbers. For details, refer to the following table.
Specified servo
Compatible device
axis number
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
Hardware test: 5Mbps
Hardware test: 10Mbps
GD10
GD11
GD12
GD13
GD14
GD15
GD16
1 to 64
GD17
For the setting other than the above, error (dedicated device
GD18
is out of range) will occur.
GD19
GD20
GD21
GD22
GD23
GD24
GD25
Description
Setting range