Mitsubishi Electric GOT2000 Series Connection Manual page 747

(2) Data link transmission speed setting switch
Data link transmission speed setting switch
(3) Mode setting switch
Mode setting switch
(4) RS-232 transmission setting switch
RS-232 transmission
setting switch
*1 The peripheral connection module operates with the baud rate set in the GOT.
➠
13.5.6 [Controller Setting] of GT Designer3
POINT POINT POINT
Precautions when setting peripheral connection module
(1) mode setting switch
(2) RS-232 transmission setting switch
Description
Data link transmission speed
setting
Description
Mode setting
Setting
switch
SW1
SW2
SW3
SW4
SW5
SW6
SW7
SW8
Be sure to set the Operation mode setting switch to "5" (MELSOFT/connection mode).
Turn OFF SW1 through SW8 of the RS-232 transmission setting switch.
If any switch of SW1 through SW8 is ON, setting error will occur (RUN LED turns off).
Set value
0: 156kbps
1: 625kbps
2: 2.5Mbps
3: 5Mbps
4: 10Mbps
: Necessary : As necessary
Set value
5 (fixed)
(MELSOFT/
connection mode)
: Necessary : As necessary
Description Set value
Peripheral transmission
OFF
*1
(fixed)
speed
OFF
Data bit length
(fixed)
OFF
Parity bit length
(fixed)
OFF
Stop bit length
(fixed)
: Necessary : As necessary
13.5 PLC Side Settings
Setting necessity at GOT
connection
: Not necessary
Setting necessity at GOT
connection
: Not necessary
Setting necessity at GOT
connection
: Not necessary
13
13 - 21