Mitsubishi Electric GOT2000 Series Connection Manual page 341

■3. [Network parameter] of GX Developer
(1) Network parameter
Network type
Start I/O No.
*1
Network No.
Group No.
*2
Station No.
IP address
Station No.<->IP information
FTP Parameters
Router relay parameter
Routing parameters
*1 Specify the same network No. as that of the GOT.
*2 Do not set the same station No. as that of the GOT.
Item
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU, operate the PLC CPU ether turning OFF
and then ON or resetting.
Set value
Ethernet (fixed)
0000H
1
0 (fixed)
2
192.168.0.19
(Use default value)
Refer to (2)
: Necessary : As necessary
5.4 PLC Side Setting
Setting necessity at GOT connection
: Not necessary
5 - 75
5