Mitsubishi Electric GOT2000 Series Connection Manual page 1179

Step 6.
Double-click [GOT] of the PLC side I/F to display [PLC side I/F Detailed Setting of GOT].
Step 7.
PLC side I/F Detailed Setting of GOT
Mark the [via GOT(Ethernet) transparent mode] checkbox and click [Set].
Step 8.
By clicking [Set], the [GOT (Ethernet) Transparent Setting] is displayed.
Here, set the built-in Ethernet port QCPU or Ethernet module, which is firstly connected via a GOT.
Step 9.
Set [QnUDE(H)] or [QJ71E71] for [Type name].
Step 10.
Specify the number for [Network No.] and [Station No.] same as the number assigned to the Ethernet
module.
When [QnUDE(H)] is set for [Type name], the setting is not required.
Step 11.
Specify the IP address for [IP address] same as the IP address assigned to the built-in Ethernet port
QCPU or Ethernet module.
Step 12.
The screen returns to [Transfer setup]. Click [Connection Test] to check if MT Works2 has been
connected to the motion controller (Q mode).
22.7 Personal Computer Side Setting
22
22 - 123