Mitsubishi Electric GOT2000 Series Connection Manual page 196

• Network range setting
Sub master station No.
(b) Control system (system A) PLC setting
• Redundant Setting
B system module operation mode
(4) GOT Side Settings
Set GT Designer3 as follows.
Setting item
Controller Type
Device setting (Network setting)
MELSEC Redundant Setting
(5) Monitoring target change when system switching occurs in a redundant system
When the system switching occurs, CPU (PLC station No.: 1) takes over the control of the Ethernet network system
as the control system.
The GOT automatically starts monitoring accroding to the specified system.
4 - 20
4.1 MELSEC iQ-R Series
Item
Item
MELSEC iQ-R, RnMT/NC
Host
Other
Control system/
standby system
➠
4.3 MELSEC Redundant Setting
Set value
1
Set value
Online mode
Contents of setting
NW No.: 1
Station No.: Station number of the control system
The system (control system/standby system) of the the monitor target can
be speified.
Only when checking [Enable Redundant Function] in the following
[MELSEC Redundant System Setting], [Control System/Standby System]
can be set.
-
Model