Ethernet Connection - Mitsubishi Electric GOT2000 Series Connection Manual

14.3 Ethernet Connection

14.3.1 Connection to FREQROL-A800/F800-E Series
Inverter
PLC
Communication
Model name
FREQROL-A800-E
FREQROL-F800-E
*1
*2
*3
*4
14 - 46
14.3 Ethernet Connection
Connection cable
Connection cable
type
• 100BASE-TX
Shielded twisted pair cable (STP) or
unshielded twisted pair cable (UTP) of
category 5 or higher
Ethernet
• 10BASE-T
Shielded twisted pair cable (STP) or
unshielded twisted pair cable (UTP) of
category 3 or higher
The destination connected with the twisted pair cable varies with the configuration of the applicable Ethernet network system.
Connect to the Ethernet module, hub, transceiver, or other system equipment corresponding to the applicable Ethernet network
system.
Use cables, connectors, and hubs that meet the IEEE802.3 10BASE-T/100BASE-TX standard.
A straight cable is available.
When connecting CPU and GOT directly with Ethernet cable, remember that the by cross cable is available.
A length between a hub and a node.
The maximum distance differs depending on the Ethernet device to be used.
The following shows the number of the connectable nodes when a repeater hub is used.
• 10BASE-T: Max. 4 nodes for a cascade connection (500m)
• 100BASE-TX: Max. 2 nodes for a cascade connection (205m)
When switching hubs are used, the cascade connection between the switching hubs has no logical limit for the number of
cascades.
For the limit, contact the switching hub manufacturer.
GT25-W, GT2505-V does not support the option device.
GOT
Maximum
*1*2 segment
Option device
*3
length
- (Built into GOT)
100m
GT25-J71E71-
Communication driver
Ethernet(FREQROL), Gateway
GOT
Number of
connectable
*4
Model
equipment
16 GOTs
100