Mitsubishi Electric GOT2000 Series Connection Manual page 367

Host station port No.
■3. [Controller Setting] and [Ethernet] of GT Designer3
(1) Controller setting
GOT Net No.
GOT Station
GOT Standard Ethernet Setting
GOT Communication Port No.
Retry
Startup Time
Timeout Time
Delay Time
(2) GOT Standard Ethernet Setting
GOT IP Address
Subnet Mask
Default Gateway
Peripheral Communication Port No.
Transparent Port No.
(3) Ethernet setting
Ethernet
setting No.1
*1 Set the same value as that of GOT N/W No.
*2 Set a value different from that of GOT PLC No.
*3 Set it to the IP address value of the Built-in Ethernet port Motion Controller CPU side.
*4 The following [Port No.] and [Communication format] can also be set.
[Port No.]: 5007
[Communication]: TCP
Item
POINT POINT POINT
(1) [Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting] and [Ethernet] of GT Designer3, refer to the following.
➠ 5.3.1 Setting communication interface (Controller Setting)
(2) Ethernet setting
The settings items for the network No. and station No. do not exist at the Built-in Ethernet
port Motion Controller CPU side. However, these virtual values must be set on the GOT side.
Therefore, set the network No. and station No. on the GOT side. Set the network No. that is
not existed on the network system and any station No..
Item
Item
Item
Host
N/W No.
PC No.
Type
IP address
*4
Port No.
*4
Communication
Set value
-
Setting (Use default value.)
1
1
192.168.3.18
5001
3times
3 sec
3 sec
0ms
Setting (Use default value.)
192.168.3.18
255.255.255.0
0.0.0.0
5015
5014
Set value
*
*1
1
*2
2
QnUD(P)V/QnUDEH
*3
192.168.3.39
5006
UDP
5.4 PLC Side Setting
5
5 - 101